Bơm lấy mẫu khí cá nhân:
20 ÷ 225 ml/phút
Model: Pocket Pump®
Hãng sản xuất: SKC – Mỹ 
Tham khảo tại: http://www.skcinc.com/pumps.asp
| 
   
Flow
  Range in Constant Flow Mode 
 | 
  
   
20
  to 225 ml/min 
 | 
 
| 
   
Accuracy
  Variance Between LCD Reading and Actual Flow Rate(after
  calibration) 
 | 
  
   
20
  to 225 ml/min ± 5% 
 | 
 
| 
   
Constant
  Flow Compensation Range (inlet only) 
 | 
  
   
20
  to 225 ml/min up to 20 inches water back pressure 
 | 
 
| 
   
Flow
  ControlAccuracy 
 | 
  
   
±
  5% of set-point in constant flow after calibration 
 | 
 
| 
   
Pressure
  Range in Constant Pressure(Multiple-tube Sampling) Mode(inlet
  only) 
 | 
  
   
1
  to 10 inches of water (1.87 to 18.7 mm Hg) at a maximum flow rate of 200
  ml/min for 8 hrs (12 hrs if using NiMH battery) 
10 to 20 inches water (18.7 to 37.4 mm Hg) at maximum flow rate of 100 ml/min for 8 hrs (12 hrs if using NiMH battery)  | 
 
| 
   
Constant
  Pressure(Multiple-tube Sampling) Mode
  Accuracy 
 | 
  
   
Pressure
  reading ± 0.5 in of water (0.25 mm Hg) 
 | 
 
| 
   
Operating
  Temperature 
 | 
  
   
32
  to 113 F (0 to 45 C) 
 | 
 
| 
   
Storage
  Temperature 
 | 
  
   
-4
  to 113 F (-20 to 45 C) 
 | 
 
| 
   
Charging
  Temperature 
 | 
  
   
40
  to 100 F (5 to 38 C) 
 | 
 
| 
   
Operating
  Humidity 
 | 
  
   
0
  to 95% non-condensing 
 | 
 
| 
   
Tubing 
 | 
  
   
Requires
  1/4-inch ID tubing 
 | 
 
| 
   
Run
  Time 
 | 
  
   
With
  NiMH: 12 hours at 200 ml/min and 10 inches water back pressure, 12 hours at
  100 ml/min up to 20 inches water back pressure 
Run time is 8 hrs at either setting if using NiCad battery 
Varies
  with flow rate and sampling media in line 
Using a charger with AC power: Extend run time  | 
 
| 
   
Timer
  Display Range 
 | 
  
   
1
  to 9999 minutes 
 | 
 
| 
   
Timing
  Accuracy 
 | 
  
   
±
  1% 
 | 
 
| 
   
Flow
  Fault 
 | 
  
   
If
  the pump is unable to compensate for longer than 15 seconds due to excessive
  back pressure, the pump enters FLOW FAULT mode. The pump goes into HOLD, the
  fault icon appears on the display, and the accumulated run time display is
  frozen and retained. After 5 minutes in flow fault, auto-restart is attempted
  every 5 minutes until flow is corrected. 
 | 
 
| 
   
Battery
  Pack 
 | 
  
   
Rechargeable
  NiCad battery pack, 2.4 V x 0.6 Ah or 
Rechargeable NiMH battery pack, 2.4 V x 1.0 Ah  | 
 
| 
   
Charge
  Time 
(varies with battery capacity and level of discharge)  | 
  
   
< 6
  hrs with Pocket Pump charger (battery attached to pump) 
Approximately 16 hrs with charger (battery detached from pump)  | 
 
| 
   
Battery
  Charge Level Indicator 
 | 
  
   
Icon
  displayed at full, mid, and low charge 
 | 
 
| 
   
Weight 
 | 
  
   
5
  oz (142 gm) 
 | 
 
| 
   
Dimensions 
 | 
  
   
4.5
  x 2.2 x 1.4 in (11.4 x 5.6 x 3.6 cm) 
 | 
 
| 
   
Case 
 | 
  
   
Impact-resistant
  stainless steel with ABS/polycarbonate 
 | 
 
| 
   
Intrinsically
  Safe 
 | 
  
   
UL
  and cUL Listed 
 | 
 
| 
   
RFI/EMI
  Shielding 
 | 
  
   
RFI/EMI-shielded
  case 
CE marked Model 210-1002TX is ATEX approved (NiCad battery model only). Contact SKC.  | 
 

Không có nhận xét nào:
Đăng nhận xét